Maxtor Hard Drive "master jumper setting" Questions

...jumper to the master position. if this drive is for additional storage, please set the jumper to slave. and make sure 1st hard drive is set to master. if this is the only drive in the system, please ...

jumper settings for master drive if its a SATA hard driveyou dont need to set master slave the biggest capacity hard drive will set as master During the boot process you will see on the screen to ...

...Master, jumper one hard disk drive to Set as Master, and the other to Set as Slave.    Use this setting if you are installing an additional hard disk drive to a single UDMA cable and ...

...master jumper setting you can find the jumper location next to the power on a hard drive and the settings for plastic jumper location is usually printed on the top of a hard driveIDE-0 means Pri ...

...DS = Master SP = Spare (Slave) Jumper settings, If you use one id cable with tow devices at that time you should hard disk jumper master & second device slave mode of jumper. hard disk ...

...for the maxtor. Select the maxtor HDD as master by setting the Jumper to the extreme left of the hdd; i.e. next to the data cable. Remove all jumpers from the other HDD which you want to put as

...jumper has to be set to Master. If it won't boot up then the jumper needs to be set to Cable select. If this hard drive is a second hard drive and is connected to the 2nd connector on the IDE data ...

Master slave jumper settings on 250gb Maxline Plus II SATA I have two Maxtor Maxline Plus II 250gb SATA HDD drives that I wish to use together in a system, neither of them is marked with jumper ...

...jumper settings for western digital hard drive model: wd400eb - 75cpfo check this official web of western digital... http://www.wdc.com/en/products/legacy/Legacy.asp?Model=WD400EB they allow you to ...

...master/slave jumper settings. 5. Find the jumpers on the circuit board of the drive. Jumpers are plastic plugs with metal sleeves that form a circuit between a pair of pins. Jumper locations are ...