Hitachi NR83A2 2" To 3 1/4" Full Head Framer with Depth of Drive "nails clipped nailer" Questions

clipped headed nails,, never use plastic or wire collated nails in that gun,, some boxes might say 30 up to 34 degree and thats fine, also in a lot of areas clipped headed nails are no longer code, so

...nails in my porter cable clipped head framing nailer... Pull lever back on top of clip, slip sleeve of nails into slot, then release lever to push nails forward as you use nails.Make sure you are you ...

...Clipped Head Framing Nailer. Gun fires everytime I pull the trigger but it often does not fire the nail. I have cleaned and lubricated but no help. Any ideas? Make sure to blow out the magazine where ...

...( as in 35,33,or 30 degree nails) Use 34 degree, paper collated, clipped head nails. They were always the most common strip nails years ago as Senco, Paslode, and a number of other nailers used

...Bostitch nailers as one they will fit into so I don't know if they will work in your gun.  The Senco part number for their three inch, full round head nails for clipped head guns is

...nail. Easiest way to remember is this when thinking of Senco strip nailers: 601 and 651 are 34 Degree clipped head nails 602 and 652 are 20 Degree FULL round head nails ...

...clipped head, 28 degress, paper held nails. I need replacement nails. Who made this nail gun for SEARS and where can I buy nails. I have seen several of these guns in the shop. I have used both ...

nails ride over each other and don't shoot straight when you put in 2 clips of nails the front of the 2nd clip sometimes rides over the back of the 1st and then they don't shoot strait. Check and make

...nails in a Hitachi - NR90GC clipped head nailer. AND is there a service manual ou there for this gun. Thanks Greg Yes, BUT the paslode Round drive nails and known to cause driver jamms due to the ...

Nail gun will not fire the nail. Compressor works fine. Hammer doesn't retract enough to hit nail? Cause, solution? could be a jammed nail in the magazine nose area, bent driver blade or problem ...