Poulan Pro Chain Saw 46cc 20" "chainsaw choke pull" Questions

Ad

Chainsaw will start and idle if choke is pulled out, but when choke is pushed in or trigger is pulled to saw (thus deactivating the choke) the chainsaw dies. Let it warm up first ...

Ad

...pull out choke control, pull starter (usually twice) while listening for attempt to start. Once it fires push choke control in and continue pulling (usually once more). Warm: pull out choke control ...

Ad

Question about McCulloch Garden

1 Answer

...chainsaw wont start when hot I suspect your warm start procedure is the fault, the manual is not correct IMO. Any choke on a warm engine causes flooding, try this, if no better post back or return it ...

Question about Poulan Garden

1 Answer

...chainsaw pp3516avx, it won't start, choke lever will not stay extended. I followed the instructions to start and nothing works The choke system is connected to the half throttle position, if you lift ...

Question about Husqvarna Garden

1 Answer

chainsaw shop. Start Procedure Cold: Ignition on/off to on Set compression release ? optional step even if saw is equipped with a compression release Pull (close) choke, set fast idle (done when choke

...to start my Solo 645 it`s always a problem prime then pull choke fully make 3 pulls push choke in half way then pull to start... no success !!! Pherhaps you should make 2 pulls. Or mayby one

Question about Poulan Garden

1 Answer

chainsaw will not start 1. make sure you have full tank of proper fuel mixture. 2. prime carb. if applicable 3. set choke to full 4. pull starting cord till it fires 5. place choke to one half full 6.

Question about Garden

1 Answer

...chainsaw if it has a primer, prime it, put it on choke, pull the rope until it coughs like it wants to start, turn the choke off and pull until it starts. that is the basics. depending on the saw ...

Question about McCulloch Garden

1 Answer

choke pull cord , blowing gas out of carb. Stuck float? Buy carb kit from local supply? No floats in chainsaw carbs. Severly flooded most common start problem with chainsaws. Read and follow the start

...chainsaw when it was new. Once you get it to fire with the choke out push the choke back in but don't pull the trigger. Then try pull starting again and let it run for a few moments to warm up. It ...

Not finding what you are looking for?
Poulan Pro Chain Saw 46cc 20" Logo

513 questions posted

Ask a Question

Usually answered in minutes!

Top Poulan Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Poulan Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...