automatic idle stays on when i use something instead of throttling up it stays idleing 4 Things can cause this, 3 of which are related. 1) Governor arm is binding, or has slipped on the governor shaft
how to set govenor on a briggs 10hp ohv 204412-0156E2 You should do an inspection of the governor linkage and spring before start, it should be in full fuel and move easily by hand. Governors tend to ...
Question about Coleman Electrical Supplies
Porter Cable 5500w generator (10hp BS) will not regulate speed. I have had this unit to the two shops. The Briggs and Stratton repair shop hooked it up to a test load and, as I told them, the engine ...
ginne stalls under load ginnie stalls under load good compression good fuel press idles fine will run 1 a/c unit at a time in the past has run 2 a/c units at the same time have removed and cleaned ...
My 5550 Watt generator hunts underload and finallly cut off, but before it stops, it slows down and then pick speed a few times and then finally shuts down? Hello, it seem that you are having a ...
...removing heavy loads - but load isn't normally connected until about 30 seconds AFTER gen has been running. Same behavior when load switch is shut off at generator. I understand the unit won't start ...
Question about Robin Subaru Electrical Supplies
I have a homelite LR4300 with the 7.5 HP Subaru engine. The governor is not working. Whats the poblem? Unclear when stated that there is a governor issue? I assume you have a Robin/Subaru 7.5 H.P. ...
I have a 6.5 B&S engine on a RYOBI lawn mower That will not come up to mowing RPM. the mower does not have a throttle cable and the spring on the throttle appear to be intach. The engine starts ...
rpm surge with intermediate power load the generator ( yamaha ef2400is , new 10 hr use ) has a throttle surge (many times a minute) when under intermediate load >< 1000w .most annoying and ...
My generator runs wide open will not idol down and is putting out 185 volts from the 120 outlet. Is this something that just started happening or has someone worked on the engine or changed any ...
64 questions posted
Usually answered in minutes!