LG WM-1485FHD Front Load Washer "stripped washing machine inlet valve" Questions

washing machine and what if any replacement seals will be needed. Information on where a service manual can be obtained would be extremely useful. My problem is also noise in spin mode - serious noise

...washing machine I've got a stripped connection at the cold water intake into the washing machine...can i replace the plastic threaded connector?.....if so, can I replace it with a metal threaded ...

...washing machine is over filling it is draining away but only if you put it on a spin the inlet water is constant and is always filling and wont cut off then it leaks from door seal and tray for ...

...washing machine is leaking from top in to drum when washer is not being used. Water valve on washer bad Yes u need a water valve. THE QUESTION WAS My washing machine is leaking from top in to drum ...

...inlet valve? My machine would only run a trickle of water into the tub so I checked the water lines for clogs. The hog water line filter was clogged but I cleaned it up & replaced it. The cold water ...

...washing machine, but cold water supply (hose and faucet) check out fine Two things will cause that problem. 1) Switch water off and remove pipe off of the machine side. You will see the inlet to the ...

...and powder. If it has come off either end, reattatch. If the washing machine is all electronic, suggest you check the solonoids on the back Lhside when the lid is off. one of them could be

...machine is off. Hi, The problem you are experiencing is a faulty water inlet valve. It is leaking, much like a dripping faucet. The only way to repair this problem is to replace the water inlet water ...

...machine to change them? Hi, Just pull the washer out away from the wall a little. You will need pliers to turn the fittings off. Be carefull when you replace them. The inlet valve is plastic and the ...

...stripped and leaks water. I have a new assembly but I need to remove the entire back of the washer. There are several screws but the back does not come off so I can acces the water fill valves. What ...