...by removing the wire plug to it and measure the sensor to be between 8.8K &9.2K (8.800-9,200 omhs) at room temp. Good luck,i hope this help ya to fix your washer, ...
...terminal and the display should constantly be in motion in as much the display will go from 1000 omhs to 20,000 ohms and just continue that if the cap. is good and the display will stay the same ...
aeg l7810 all programs sticking at rinse cycle. I've checked the filter and drain pump works ok. The heater is working ok also. Please could someone help me? Hi I think it could be the rinse water
...where the door mounts,check that when the panel is off that those switch are closed and have ZERO omhs resistiance and the are open when panel is installed. To do the DISCONNECT POWER TO WASHER, ...
...wires they are) to test it when the lid is closed on those 2 wires should have continuty with ZERO omhs resistiance and when the lid is open the that circuit should be opened ...
Question about Ariston Technologies Washing Machines
...select continuity it will beep. If you have a Ohm meter select a low range you should get around 23 omhs.Lastly the brushes in the motor could of worn, or the motor itself could be wrong do a ...
...5(UI). All the measurements made should be less than 5 ohms. If any of these measurements exceeds 5 omhs, go to step E.D. Replace the appliance manager. Ensure all connectors are properly inserted.E. ...
87 questions posted
Usually answered in minutes!
1,845 Questions
401 Questions
243 Questions
245 Questions
234 Questions