...put wheels at desired height ,or you would have to unbolt your wheels from the deck and place them at your desired height. The deck would have a number of holes in it for just this purpose. GOOD
...height is achieved by raising or lowering the deck so it sounds like you really only may have one problem. If the height adjustment lever is stuck and will not move, it should be fairly ...
...Adjust the rear height adjustment so the second to last notch is engaged.Position yourself with one knee on the front deck. This will allow you to control the height of the front and the ...
...deck ,these are your adjustment holes.You would unbolt the wheels and put them at the height you would like. If as you say there is no adjustment, I would say buy new wheels that are an inch or more ...
how do I remove the mower deck undo all connecting pins and height adjuster rods and push the mower back over the deck
...deck with the height selector lever set so the anti gouge wheels suspended in the air. The side to side tolerance is about 1/8" max. Next measure the bottom lip in front and back (center), the front ...
What is the name of the lever that adjust the height of cutting? The deck adjustment lever.
height adjuster tight on both sides? if loose the bolt holes may be elongated, both sides set the same? any wheel wobble indicating worn out wheels?.if it checks out as good put the machine an a known
...adjust each wheel so the blades are at the height you want it to be. Make sure all the wheels are all at the same height. Usually, the bottom of the deck lip to the floor equal all around. There's a ...
Question about Briggs & Stratton Garden
...deck is at its closest position to the ground, there is no further factory adjustment. It may be possible to shim the blade with a washer, or to install smaller wheels, but I would NOT recommend ...
787 questions posted
Usually answered in minutes!
213 Questions
216 Questions
140 Questions
63 Questions