Question about Teledyne Laars Pool & Spa
...just put in. check gas pressure and the size of your line if too small a line and too long a run from the meter it will run out of gas in line then line fills back up heater fires and drains line ...
Jandy, Lite 2 Pool heater wont kick in is there a specific size pile line needed to go to Jandy, Lite 2 pool heater? Thank you 3/4 pipe line will work and will keep heater from sooting up.
how to install new pool heater Shut the pump down. Open the lid on the pump to allow into the system. This will drain the plumbing lines at the equipment. Drain water from heater by removing drain ...
...heater runs 4 about 5 min. Then shuts off including pilot. Filter is clean .getting plenty of water pressure. Gas line has no leaks. What's the problem? check to see if gas pressure is correct sounds ...
...line outside the heater and the one inside the heater. They may both be on, but there could be too much air in the line. To vacate this, try turning the heater on at least a dozen times. A ...
...heater isn't wired to the line side of the timer. It should be wired on the load side, NOT the line side. Problematic at best to have your heater powered all the time, at worst deadly to the heater ...
...heater the line loops up over and down. There are two unions on this at the base of the loop. take these apart and their is a washer in one and you replace it with the Propane washer and put back ...
Question about Teledyne Laars Pool & Spa
line to heater then you have a flare nut. With NO flames or sparks even close - NO SMOKING !!!Carefully & slowly loosen either the union or the flare nut with gas valve open. You will hear hissing
246 questions posted
Usually answered in minutes!
193 Questions
170 Questions
177 Questions
72 Questions