how can I tell which wires go to the pool light and which come from the power box? I think animals have chewed through the power wires and want to check it out The pool light wires look like a black ...
...LIGHTS WERE NOT EVEN ON. WHEN WE HAD THEM LIT, THE LIGHT SWITCH MEANT TO TURN ON THE FIREPLACE WOULD NOT TURN IT ON. I SHORTED OUT THE WIRES AT THE FIREPLACE TO SEE IF THERE WAS A PROBLEM WITH THE ...
...switch and thermostat - this is millivot heater-natural gas if burner lights after jumping valve you have something wrong in thermostat loop. disconnect the 2 thermostat wires on gas valve and use ...
how to you replace the pressure switch on an arctic spa My flo light is on for pump 1. Tried all trouble shooting tips. How do I replace the pressure switch which is listed as a possible solution ...
I just replaced the pilot generator on a jandy lite2 and the pilot stays on but the burner will not light. I am getting over 500 millivolts at the gas valve. Any ideas? Thanks 500 millivolts is good ...
...your lights, turn the switch on, then back off, then wait between 11 and 14 seconds and turn the switch back on. When the lights come back on, they should enter program #1, and be
...lights come on. Cycled on off switch and circuit breakers, yet still only pressure sw light comes on The indicator light means your pressure switch is not closing therefore the heater will not fire. ...
Question about Pool & Spa
How do I reattach the tube that leads from the light button to the air switch in the control panel? I can not find the air switch. Turn Off your Circuit breaker. Remove Spa Panel. Locate the main ...
282 questions posted
Usually answered in minutes!
774 Questions
131 Questions
104 Questions
113 Questions
87 Questions