water temperature thermostat misread water temperature is misreading (too high) causing the pool/spa not to heat properly. The system turns the heater off due to the temperature misread. You most ...
Question about Jandy Pool & Spa
Aqualink RS4 Water temperature reads 120 - obviously wrong. Water temperature reads 120 - obviously wrong. Can I disconnect temperature sensor so that water temperature is low and the solar will ...
heater temperature control buttons Hi, I have a hayward h250 digital heater, the buttons to raise and lower the temperature are not working. The current temperature is displayed and the heater fires ...
The temperature on my Nordic Crown Hot Tub stays around 89 to 91-92 degrees. I would like to hike it up to at least 98-100 degrees. I push in the temperature ''button'' and it blinks the temperature, ...
Raypak heater Set Point goes no higher than 70 On my Raypak heater, the Set Point goes no higher than 70*. Because that temperature is lower than the water temperature, the heater does not turn on! ...
Question about Jandy Pool & Spa
temperature contro pot to max?Do you have any thoughts?Thanks,Bill Thermostat is bad. There is a micro switch behind the dial that reacts to the temp probe and you may try cleaning it out first but in
...the Temperature Hi Limit sensors share the same 4-Wire plug, you will have to replace both. If your sensors have a telephone style plug you can replace the Hi Limit with out replacing the Temp
The temperature for the pool on my Aqualink System is off; it is saying the water is much warmer than it actually is. It appears the thermometer that reads the temperature to the system is broken. How
Question about Pentair Pool & Spa
my master temp 400hd says that the water temp is 98 when it is really 73. The heater comes on and heats the water to 104 but it is really only 79. What is broke? The temperature is not reading the ...
459 questions posted
Usually answered in minutes!