Troy Bilt Pony 6.5 Hp Rear Tine Tiller "tine shaft oil seal" Questions

...tine shaft oil seals - Junior model How do I remove the tine shaft oil seals on a Troy-Bilt Junior V (Mod # 15006, S/N M0104189)? The outside of the tine drive housing has a silver-colored disc about ...

...the tines off to replace the seals. The tines sometimes get frozen to the shaft. You might try penatrating oil and use a heat gun or hair dryer to heat to loosen. Also tap wiht a hammer around

...tine shaft Can't find serial number on tiller that has a 6hp motor and is about 30 years old and need a oil seal on the rear tine counter shaft. I also can't find a serial or model number. The serial ...

...of the transmission. remove the plug wire if you attempt to pry out the old seal and tap in the new seal. Be careful not to damage the case and grease the seal and shaft when you replace the oil ...

...tine seals are leaking ive taken the bolts out but the tines will not come off what can i do You could try putting the tiller to use, preferably where it will have to work hard to till the ground it ...

...tine attachment will not budge any suggestions please Have you tried soaking the shaft area with either PB Blaster or Deep Creep penetrating oil. Try this for a few days before trying to tackle ...

...of "clean" oil under it! does not appear to be engine oil .. gear case maybe? Look at the shaft seals on the output shaft where the tines are attached. If it's wet then the oil came from the gear

...oil but most likely the output shaft seal has been gone for a consdierable amount of time and has leaked out and is just now making noise, they don't normally make noise right away after the oil runs ...

econo-horse tillerser.#e023842 need new oil seals on tine shaft You can order them from your local MTD dealer.

...You dont even have to drain the gear oil. Getting the wheels off the wheel shaft is sometimes a problem if they are rusted on. if you can get the wheels off its not to hard to change the seals. ...