Troy Bilt Pony 6.5 Hp Rear Tine Tiller "roll pin" Questions

...roll pin goes through and it won't shift into till. sometimes you can drive the roll pin out, pull off the lever and peen the holes over. sometimes you have to drill the lever and shaft and put in a ...

...to move the tiller backwards. When the tiller is shut off the tires will not move. The only way to roll around is to remove the pins on the axle and slide the wheels in and replace the pins. If this ...

...roll pin. Pound out the roll pin and pray.....that the rims aren't rusted to the shaft. If the rims are rusted to the shaft, you have two choices. You can either put the new tires or tubes on the rim ...

...roll pin extractors ($20 from Sears), new roll pins, new woodruff key for shaft. You will also probably have to press 2nd stage impeller from shaft with hydraulic press & heat (took mine to my ...

...free wheel the tiller you have to remove the pins that go thru the wheel rim hubs and then it will roll without starting it. Hopefully the rims are not rusted to the wheel shaft. ...

...from separating. How do I remove the tine gear from the right gearbox cover (with chain) in order to totally separate the two halves? check to see if there is a snap ring on the shaft or a roll

tiller has been sitting up for some time and now won't engage into forward or reverse. Hello. make sure all of your clevis pins are in place. And on mine even if i get it in gear...make sure that the

rear tine craftsman wont engage in any gear. feels like there in no connection from handle cable to engagement That is correct "Only if the shifter cable isn't broken!" And if it is a linkage type, ...

My tiller rear tines are rubbing against inside metal. It appears the tines shaft bar has slide to one side. Unable to move back. Any ideas how to fix open the center case and check the roll pin ...

Drill out wheel roll pins ??? the roll pins should only need to be driven out with a punch they are hardened steel and would be hard to drill out anyway