shaft oil seals - Junior model How do I remove the tine shaft oil seals on a Troy-Bilt Junior V (Mod # 15006, S/N M0104189)? The outside of the tine drive housing has a silver-colored disc about 45 mm
...oil seal needs to be put onto the output shaft of the transmission. remove the plug wire if you attempt to pry out the old seal and tap in the new seal. Be careful not to damage the case and grease ...
Question about Garden
...of "clean" oil under it! does not appear to be engine oil .. gear case maybe? Look at the shaft seals on the output shaft where the tines are attached. If it's wet then the oil came from the gear
...the tines off to replace the seals. The tines sometimes get frozen to the shaft. You might try penatrating oil and use a heat gun or hair dryer to heat to loosen. Also tap wiht a hammer around
Question about Troy Garden
...seal to the depth the old seals were installed at. You dont even have to drain the gear oil. Getting the wheels off the wheel shaft is sometimes a problem if they are rusted on. if you can get the ...
oil seal for rear tine shaft Can't find serial number on tiller that has a 6hp motor and is about 30 years old and need a oil seal on the rear tine counter shaft. I also can't find a serial or model ...
...oil but most likely the output shaft seal has been gone for a consdierable amount of time and has leaked out and is just now making noise, they don't normally make noise right away after the oil runs ...
so that the shaft is loose new seals will not hold up and you will risk doing further damage to the worm gear located on rear shaft and possibly other damage to your transmission from contaminated oil
...oil had been working on it for two days of repeated applications. The Bushing and seal were shot, made a new bushing and will not replace the seal. There is no way for lubrication to get that far up ...
139 questions posted
Usually answered in minutes!
Step 2: Please assign your manual to a product: