Dremel Mini - Mite Cordless Rotary Tool "loosen collet nut" Questions

loosen the collet. Slow and steady should get it loose. Another option is use some penetrating oil sprayed lightly onto the back of the collet to help loosen it from the shaft etc. Same thing happened

...on the collet nut and loosen the nut. If the bit is stuck just tap the end of it slightly to loosen it and it should come out. Reverse this process to install a new bit...hope this helps ...

...Collet nut loosened, the bit that's in there will not budge. I even took the Collet nut right off to make sure there was no pressure and it's acting like one solid piece between the ...

...loosen the collet to remove it. I tried pressing down on the red button and loosening the collet by hand (as the directions said), but still cannot loosen it. Can anybody help? Looking down on the ...

collet nut either with the collet grip or a wrench and the bit does not come out. Remove the collet nut completely from the tool. Remove the the collet with the bit in it. With a couple of plyers, one

...loosen the collet... Can I buy those 2 pieces? call dremel and ask for the part need you model number so have it ready Dremel Service CenterDremel Authorized Service 4915 21st Street4631 E. Sunny ...

collet to loosen the bit then change bit tighten up and you are away lol hope this helps regards Jim I have this tool. First, lock the shaft with the shaft lock on the end of the tool (pull back on it

collet nut that will not loosen. at one point while turning the shaft lock button pops up; even when pressed Sorry, but I seem to have ( essentially ) the same problem... no positive lock. holding the

at the top is pressed in and won't come out. The button is only to keep the shaft from turning while you loosen the collet (the nut) with the little wrench.   THEN the tool comes out