Poulan/Weed Eater #Wt200 711724 24cc Gas Blower/Vac "gas blower fuel primer" Questions

...blower. It starts fine but seems to run out of fuel. I can keep it running by pumping the primer bulb every 5-6 seconds. I checked the filter and it is not blocked. Lines are not kinked. Hi Priming ...

...gas would be dripping out of it when not attached to the blower It's like the primer is bypassing the carb. On a previous post it was recommended to check the fuel filter, and line. Well, nothing ...

...gas injector does not work The primer does not necessarily need to work for the unit to run. It does have a choke to aid cold starts. However it is a good indication of something wrong in the fuel ...

...blower, primer bulb will not return to normal once pushed in, carb has been cleaned, all fuel lines have been cleaned and checked. when fuel is dumped directly in, it runs fine.Diaphram in carb does ...

...Blower will run if primed manually. remove your carb and clean it and replace diaphram's and needle , they tend to swell up from ethanol that is used in the gas now a days, and the diaphrams turn ...

gas might show up in the fuel tank. Remove fuel. With carburetor cleaner, spray carburetor. Put in small amount of fresh fuel. Just enough to cover the fuel filter. Then press primer with fuel cap off

...of gas now there is no gas coming into the primer bulb on the back of the blower check to see if your gas filter is stuck inside the gas tank... it should sit loose at the end of the fuel pick- ...

...t fill Primer bulb to start blower- how to fix problem? which part to replace? well start with the fuel lines, then suspect a bad carb YOU HAVE THE PRIMER BULB HOOK UP WRONG TRY CHANGING THE FUEL ...

gas does not wok leaf blower does not startand I can not pump gas with primer The primer does not necessarily need to work for the unit to run. It does have a choke to aid cold starts. However it is a

...gas into the carb. Any ideas as to what my be the cause? I assume the new tank came with new fuel lines and filter in it. First be sure you have all the lines hooked up correctly. There should be a ...