...not reverse out of neutral, controller beeps once periodically. forward works and reversing directly after forward also works. Hi, I'll try to help.Is your speed setting on 1 or 2 before you
...forward thereby changing the pot wiper and getting the error. Contact Pride about the problem at 1-800-800-8586 and ask for Tech support for scooters and explain your problem to them. I hope this ...
...forward using left hand, reverse using right hand, if so there should be 1 red and 1 black wire from the motor going to the motor controller if you switch these wires then your throttle should work ...
Question about Electric Mobility Health & Beauty
...1 tested.please can anyone help. Hi. This sounds difficult. I have had a few scooters move slowly forward or in reverse, but not both. Normally if the speed pot ( wig wag ) is not exactly in the ...
speeds if u leave the key on and is slow in forward only it will only stop in reverse if you turn of key or disconnect the forward or reverse control switch can you help please im thinking the control
...sure. If you have bad batteries that will make you scooter do what you say it's doing. Don't forget your reverse speed is only 1/2 as fast as the forward speed on all scooters. Good Luck ...
Question about Health & Beauty
...forward but slower, let go of throttle brakes abruptly. checked the wires back to the control box under floor, throttle neutral position is 2.6Kohm, full one way 4.96Kohm, full other way 0.6ohm, no ...
Question about Pride Mobility Products Health & Beauty
...is: Throttle control fault. 1. Check wiring for open/short circuits. 2. Check the throttle set-up.... The ohms should be very close to each other when placed checking forward and reverse on set
...forward or reverse Daniel It could be the throttle pot or speed pot or even the motor itself. The clicking sound you hear is the electric brake being energized when you depress the throttle. This ...
...1-8Testing1 Remove any covers in order to expose engager lever assembly.2 Check the resistance of the two outside terminals of the engager potentiometer with the multimeter, the reading should be ...
135 questions posted
Usually answered in minutes!
140 Questions
116 Questions
82 Questions
61 Questions
58 Questions