Crosley Arlington Stack-O-Matic CR66 Shelf System "lift" Questions

turntable removal the fisher mt6410 turntable does not have a ring lock so it still lifts slightly and the sticks. Some t/tables have a rubber mat held in place with adhesive. Lift mat around spindle ...

...or is there a manuel or schematics to this system? You will need to check your belt for wear. Lift felt on platter and check belt tension. It may need replacing. To replace, simply lift platter ...

...pg. 15), but it didn't work. CD tray will not turn or close. Take the 4 screws out of the top, lift the CD drawer out, disconnect the two wire harnesses, take the top off, lift the 3 disc tray ...

...two each to shine on the CD and casette respectively) Remove glass doors,black panels 8 screws lift up cd clamper and detatch from drive bar at top l/h corner.Lift operating panel to gain access ...

...its brand new and i'm not sure if i'm doing it correctly. Turntable will not turn You have to lift the tonearm up, and move it to the right slightly. This starts the turntable moving. Sounds ...

...removeable base, you will see 2 rectangular openings, and inside these openings is a tab, that you lift up (it will seem like you are going to break it, no, its designed this way) lift those up,

...usually through a hinged/retracted gear-tooth), the platter would spin the cam, which in turn would lift the tone arm, move it back home, shut off the power and disengage itself after one complete ...

...are a few possible causes. 1. Lens on laser pickups dirty. 2. The belt that closes the drawer also lifts the CD assembly to allow disc to spin. If the belt is loose, drawer may close but not be able ...

...needs replacement. Sometimes there is a C shaped clip holding the platter on. If so remove it and lift the platter. Otherwise the platter just sits on a bushing around the spindle. Lightly lift the ...

turntable does not turn Lift platter and refit belt. [email protected]