Question about Home Security
...sensor light. The reason why installed, but can not turn off, might you install in the wrong way. You can see the installation details Pir Sensor Led Tube 4ft why did it have this situation ? ...
light sensor which is available at most hardware stores or you can disable the motion sensing feature and just have an on-off light. To disable the sensor, (turn off the power!) unscrew and remove the
Question about Heath Zenith Home Security
sensor security light.Just turn the light switch on.When the sun goes completely down,somebodies or anamials go by the sensor covering area the light will go on.The sun rise the light will go off,will
Question about Heath Zenith Home Security
...sensor red light is coming on but the additional load of the floodlights' current may not flow if there is a loose connection, very little current needs to flow to operate the sensor.) (The wires ...
Question about Desa International Home Security
...light and the sensor, now I would like to disconnect the sensor. You should be able to set it to manual,according to this,http://feed-building-platform.com/907015007.html Look for a slide switch on ...
Question about Desa International Home Security
...sensor or light to keep the sensor in the dark when the lights are on... If the unit is hard wired, try turning off at the box for about two minutes and then back on. lights will come on for ...
Question about Heath Zenith Home Security
...light for 2 years with no problems at all. recently, it seems that the "left side" of the sensor stopped working. (If I walk right in front or in the right side, the lights will come on), ...
...light will flash after pressing *2 1=Service Required (press 1 to get sub codes) 1=Low Battery 2=Bell Circuit 3=System Trouble 4=System Tamper 5=Module Supervision 6=RF Jam Detected 7=PC5204 Low ...
...light. Bad mother board, door sensor or door magnet? 1999 system no other lights on Led keypad. Will not arm without all doors closed. Hi , to test door magnet put close a small piece of iron, it ...
...lens (where the light strikes the sensor) is not weathered so back that it deflecting light. If it is dark, light cannot enter the sensor thus not allowing the unit to shut off. Hope This
132 questions posted
Usually answered in minutes!
2 Questions