Question about Panasonic VIERA Televison & Video
red light. 1. Subject Information of LED Flashing timing chart. 2. Contents When an abnormality has occurred the unit, the protection circuit operates and reset to the stand by mode. At this time, the
Question about Panasonic VIERA Televison & Video
...red light is blinking 7 times--repairman says it needs an SD or SU driver board...$300 plus...cannot afford. Tried to oder the part but do not have a part number, can anybody offer any suggestions. ...
Question about Panasonic VIERA Televison & Video
...number for Panasonic Tv see if there are any problems with that model that the manufacturer has extended but does not post. I had one repaired that the red light on also so I understand and it went ...
...red/green. Have to switch on with on/off button after a few minutes switches off itself..........then back on itself Power LED Blinking timing chart When an abnormality has occurred the unit, the ...
Question about Panasonic VIERA Televison & Video
...red light flashes Back-light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site ...
red light on main board I have replaced the number 1 and 3 inverter boards on my Sharp LC-52D64U 52 in LCD HDTV and now it turns on again. My question is should the red led on the main board turn ...
...and adjust it so it is white. If all is well, that is all you need to do. However, there are a number of failure modes that could cause this symptom; most of them would be on the red CRT driver
...red flashing on (Main board) These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section ...
Red light blinks an odd pattern One long blink then a couple real fast blinks Thats most likely a error code. But I will need the model number of the set and the exact number of blinks such as 1 blink
...red. 3. Press each of the number buttons 0-9 until the LED blinks once. This will signify the 1st number in the 3-digit code for the device that is programmed in your remote control. 4. Repeat same ...
717 questions posted
Usually answered in minutes!
346 Questions
268 Questions
236 Questions
213 Questions
189 Questions