Masterbuilt 20070106 Electric Smoker "40 heating" Questions

hair dryer, and heat up the heat sensor until it is above 40 dgrees. The unit should start to heat up. Keep it on the sensor until the unit is heating for a minute or two, it should stay on after that

Hi, my patio heater, (large stand up type) has been acting up recently. When it's below 40 degrees the regulator seems to freeze up and the burner slowly goes out. I usually have the tank valve op

...40 yrs old. Can I buy a heating element for it about 4 inches dia. Instructions say place in box when smoking, I didn't do that last time. The chips smoked very slowly after the first hour. I ...

...turn on gas, like the other on if the knob is stuck remove it and spray the valve heavily with wd-40 while pressing the stem in and out and in and out and in and out and slightly wiggling to turn. ...

...Rub roast all over with salt, pepper and ground sage. (This is a basic pork seasoning.) Roast 35-40 minutes per pound, until done (this is correct for a rolled roast; bone-in roasts don't require ...

...40 inch stainless steel masterbuilt smokehouse. The coil/heating element whatever you call it had a blowout. Melted a hole in it. is this replaceable and where can I get one. I have the old one off ...

...40 degrees. Warm it with a hot rag or hair dryer, or bring the unit inside to warm up and it will turn on. Once the unit turns on for a minute or so, it will work fine outside. This isn't the ideal ...

...heating the bbq. What should I do? I also can't unscrew the flame burners as the screws that are holding them in place are rusted and cannot be moved even when sprayed with WD-40. Help drill the ...

Display is reading EAAF. What does that mean? If the internal temp is less than 40 F you will get his code. Warm up the heat sensing probe and it should work just fine. If not here is the contact ...

...lost their heat. We've never had a problem with briquettes and have been cooking on BBQ's for about 40 years. Is there a special technique when using cottonwood? I've only used Cotton Wood twice. ...