Carrier 38BRC036 Air Conditioner "not cycling" Questions

no error message.. unit turns on,cycles and does not come back on The unit (at the thermostat) has to be off. When we turn on the thermostat the furnace comes on, may or may not cycle more than once ...

...not cycling at the correct temperature allowing the overtemp condition. The cycling control will be very close in external appearance to the limit switch but it will not have the red reset button and ...

...not a solution, but---. I had to set thermostat all the way up to 86 (high as it would go) and remove front panel entirely. It now cycles OK on energy saver but will sometimes get too cold. Seems any ...

indoor blower wont run on cool cycle blower works fine on heat cycle and when manually on, will not run on cool cycle ????? sounds like a wiring problem. the t-stat fan on position uses high speed on ...

...not blowing on the thermostat, have replaced both capacitors, and replaced the thermostat about a year ago. The unit is cooling well but I am concerned that the short cycling will burn out my ...

...cycling which I'm sure is horrible for the compressor. We camped recently where there was an electrical issue with our box where it was not providing proper power to the RV. The problem ...

...with a snowflake and a waterdrop within the circle. Does anybody know what alarm tjis is? It does not show in any manual. Thanks and regards This may just be the defrost cycle for the outdoor unit. ...

not running at the proper speed or you could be low on refrigerant. If it's cycling on the high pressure switch then it could be a dirty condenser coil, outdoor fan capacitor or fan not running or not

...cycling on/off but is not cooling because is cycling on/off ?what i am supposed to dm if you are running the air conditioner with a extension cord it will most likely cycle but the compressor wont ...

...not cycling We really need more info. Does the blower now come on? Is it the outside condensing unit that doesn't "cycle"? Did you check for power? Did you check T-stat wiring? etc. Usually when a ...