fan limit was not replaced correctly. You can try switching the blower to the On position (instead of Auto), if the furnace runs properly with the blower on that would be the most likely culprit
blower assembly (see Forced-Air Distribution Fix-It Guide). If the furnace is noisy, make sure access panels are mounted and fastened securely; spray squeaking belts with fan-belt dressing and replace
...furnace, I returned power to it, then pressed the safety switch so I could see everything happening. The LED on the control board lit for 1 second, went out, then the relay clicked, the the motor ...
furnace m/n gmnt080-4b. the problem is that the blower the forces air through the vents wont stay on, even if i turn the fan switch to the on position. it turns on for around ten minutes and the shuts
...blower will purge all gasses from the furnace and pressurize a pressure switch. Once the pressure switch tells the module to continue, the electronic ignition will energize and send 120 volts to the ...
...furnace. filters is clean. it will start to light then stop . Several times of recyling power normally brings the furnance up. Though the failure code has always been 31, there are several different ...
...furnace, I returned power to it, then pressed the safety switch so I could see everything happening. The LED on the control board lit for 1 second, went out, then the relay clicked, the the motor ...
...blower motor to come on until the limit control reaches a pre-determined setpoint in the heat mode. The a/c mode it will start up all at once. Not knowing how old this unit is, I looked it up and it ...
...furnace. If the air conditioner is for cooling only the unit will usually have only two wires going to the condenser unit. Make sure that you have 24 volts across those wires. The next thing to check ...
424 questions posted
Usually answered in minutes!
334 Questions
307 Questions
96 Questions
89 Questions
65 Questions