Question about Sanyo Microwave Ovens
The internal fuse in my Sanyo G400 microwave goes when door is closed and the power is swithed on. Check the door switches and its connections if o.k then check HT capacitor for short circuit.
...ht capacitor area is the first time it warmed the popcorn and no more. tried again no sparks but there was no heat at all. checked fuse ok no visible burn areas. had ge serviceman change magnetron ...
...fuse is blown to check varistor. Where is the varistor located and how do I check it? Chances are if the varistor fails, it fails drastically causing a short circuit across the supply. It will sit ...
...time even after the device is turned off at the mains. If the internal fuse has blown, then this can be replaced however it may indicate another problem with the HT power supply side of the
...ht voltage or receiving but faulty, then your micro wave wont work please take precaution when opening micro wave due to high voltage caps that remain charged sometimes even when it is off.check the ...
Question about Panasonic Microwave Ovens
...fuse that needs replacing? the microwave ht transformer has a core in the middel that has burnt out .solder loos take the ferite inductors apart and pull the center of the transformer out inspect for ...
...fuse If there is spark please do not switch on unless you have confirmed the fault. It is possible that the Magnetron is leaking and sparking to the ground. As you have mentioned it was stored, it ...
fuse still blows,take note that the high voltage side going to magnetron is already isolated,can you give me an idea on what to do?thanks Possible that the high voltage CAPACITOR or the transformer is
When the door is open, NO HEAT. Check em out. this problem occurred when magnetron not working. unplug microwave and open the cover. check fuse link of ht transformer.if fuse is ok. replace magnetron
Question about Microwave Ovens
HT fuse was replaced and working for a few days then blows again! Forget the control board as that has nothing to do with the hv fuse and if that is blowing then the board is turning the magnetron on.
23 questions posted
Usually answered in minutes!
87 Questions
86 Questions
61 Questions
33 Questions
27 Questions
