Question about Wahl Health & Beauty
clippers just stopped working...just gives a light buzz oil your blade after each use. on the side there is a blade adjustment setting. after you oil the blade turn your clipper on, turn the set screw
...clippers and halfway through the cut it stopped working and started pulling my hair out. i bought these on the premise that they are self lubricating and dont need oiling. they are Remington HC320C ...
clippers I can`t work. Thank you!!!! This is from the Oster book: Changing Blades To Remove: IMPORTANT- stop motor; push latch with thumb while lifting blade away from clipper and slide off tongue. To
I have an Andis Ultra Edge dog clipper that worked very well on matted hair for the last two years. Previously had #10 blad now used #5. Worked well half way through cut and now stopped cutting. I ...
Question about Wahl Health & Beauty
...clippers and they worked fine until last night , they started to chatter very loud and so i adjusted the voltage screw on the side but they just won't quiet down. any suggestions? 1 or 2 basic things ...
...clippers hard in the palm of your other hand they start to work again but stop in a few seconds. Also when they where working and you put the plastic clip comb on the blade, they would start to ...
...clippers seem to work well for about 10 minutes, then will not cut through the hair. They sound fine, just stop cutting. I have a Oster Golden A5. It is about 12 years old but not overly used; bridle ...
oster showmaster clipper motor will not run Had a short in the cord, took the unit apart and corrected the problem. Was trimming our goat when they stopped working. Motor will not run cord is still ...
Question about Oster Health & Beauty
...clippers hard in the palm of your other hand they start to work again but stop in a few seconds. Also when they where working and you put the plastic clip comb on the blade, they would start to ...
...stop cutting .it has worked well for 3 yrs . i just replaced the blades . please help i cant figure this one out if you put oil on the blades does it help if you remove the blade you should see the ...
23 questions posted
Usually answered in minutes!
65 Questions
52 Questions
58 Questions
31 Questions
25 Questions