...head is actually tilting back and forth ~1/4 inch when it operates. why has it started doing that? back and forth? please be in more detail.. Hi, Check the mixer's accessories, these should be fitted ...
...head. 2) look for a notch in either the top edge or the bottom edge of the casting. (hole) 3) Guide Pin on 9xx accessories is at the top of the connecting shaft. 4) if notch and pin point in the same ...
...Head screws. 6. Remove plugs (2) 7. Pull top cover off. This can be tricky. Some pulley pullers will work, if they have thin enough arms to reach through the plug holes and fit between the cover and ...
Question about KitchenAid Food Mixers
...head up, fit bowl & flat paddle. Lower head & turn machine on low, listen for paddle tinging on bowl, if it is touching turn off and raise the head. Look into hinge area from the front, that ...
KITCHENAID MIXER WON'T TURN ON ? the model that won't turn on is my KITCHENAID MODEL K5SS Remove the brush caps on the sides of the motor housing and check the carbon brushes. If they are worn out ...
Question about Sunbeam Food Mixers
head" of the mixer). How do you get these out? Any tips on disassambling the rest of the mixer to be able to put a new cord in? I haven't tried to take the rest apart, since the two screws I mentioned
...head flange. As you attempt to seat the drip ring, if it will not stay on, then rotate the drip ring clockwise, just a bit, and repeat the process. Ideally you should find one position where the drip ...
...head screw. 4. Work around the edges of the two halves until it comes apart and you are able to free the slider from its return spring. Replace the cicuit board completely if available. Or resolder a ...
fit securely and stay in place. Give the drip ring one final squeeze for good measure. Keep an eye on the drip ring the first few times you use the mixer to make sure it is not working loose again. If
Question about KitchenAid Food Mixers
fit bowl & flat paddle and adjust head height with the screw that you can see when the head is raised up. The screw is right in by the middle of the hinge for the head unit. Screw it in (clockwise
2 questions posted
Usually answered in minutes!
493 Questions
357 Questions
285 Questions
205 Questions
183 Questions