FoodSaver Smart Seal Vacuum Sealer V3825 "enough space" Questions

...enough space between the pulley and the plastic after u get it in bring the roller brush close enough to put the belt around it then stretch it back to the slots for the roller maybe that will ...

space between the shaft and top cover is very narrow. You just have to push thru th opening to around the shaft, then put it on the brush roll. Th belt will stretch enough to re-install the brush roll

...causes the plastic housing next to the pin to move toward the front of the vacuum providing enough space to slide the belt off easily. Be careful that you do not apply too much pressure with the

...space. My dyson quit working and now it will not turn on can you please help...??? I know I didn't **** anything up but I can't live without a vacuum!! I have tried the brush reset button but can't ...

...space between it and the casing. I spent an hour trying to do this and couldn't get enough purchase to get the belt around the spindle. Instead I put it around the spindle first, and then through the ...

space between the rail and the back of the vacuum, and tap lightly with a hammer. Tap toward the front of the vacuum a few times until the rail is far enough forward to be slid out fairly easily. As a

...enough to misalign the cogs. There's about 3 mm of unsupported space for the roller brush cog to twist out of alignment so I filled that space with a rectangular piece of plastic approximately 50 mm ...

...space on which the switch is located becomes packed with dirt, dust and hair and the switch begins to actuate every time you make a hard swiveling turn. Eventually, if you get enough crud packed in ...

...enough room to seep in. 4 Affix the lid to the FoodSaver vacuum sealer canisters. If, after sealing a canister, you can remove the lid without depressing the vacuum release button, the vacuum seal ...

space between the circle and the square to force the walls back to square. I started by folding a little piece of aluminum over and over so it was about three layers thick. Jammed that in. That wasn't