Eclipse Premium 34230 Car Audio Amplifier "remote red light stays" Questions

...red light goes off If the protection LED lights only after the remote voltage is applied (head unit is switched on), the amplifier likely has shorted output transistors. If the protection LED remains ...

...red light on the front stays on and kills my battery WHY??? Radio is probably still feeding power to amp from remote wire....One fix is to run a toggle switch between remote wire from radio and

...short. If you remove all speaker wires and rca wires and all you have connected is the ground, power(12volts) and remote and it still lights up red/green(in protect mode) then your problem is the

...red protect light stays lit. possible cause and solutions please 1 your stupid 2 your stupid 3 your stupid 9 times out of ten it's your remote wire if your hook up for our radio for your remote wire ...

...remote wire but still no luck. The red led is the protect indicator. When this stays red you have either a bad speaker or the amp has a blown channel. Those are the 2 most common problems with the ...

...red light is staying on and no sound what can the problem be. check the cord from deck to amp when you trun on the deck it should go from red to green some of amps you do need to run a blue wire from ...

...red protection light came on. i have checked the connections and the power cable is fine, the remote is also ok and the ground is fixed to bare metal in the car. please help! Does it go into protect ...

...then shuts off. not red but just completely off. i checked my fuses and everythings ok. any suggestions? You need to use a multimeter to confirm that you have both B+ and remote voltage at the

red lead alternately to the B+ and remote terminals. If the voltage drops below ~11 volts, you need to check the wiring feeding whichever line is dropping too low. If the voltage remains near or above

...remote connected and power up the amp. If it turns red instantly, then the amp is shorted/blown. If it stays green, then install your speaker inputs and outs one at a time. make sure your amp is on ...