Craftsman Shop Vac 8 Gallon Replacement Filter "separate stuck filters" Questions

...separate the two halves. 3. Grasp the filter tab to lift it up. 4. Empty filter, replace, reassemble. Wouldn't that be nice if it worked like that? Mine is completely stuck together and will not

...stuck in the hose. I've tried prying it out with a hanger and only succeeded in getting it further down the hose. Is there a way to get the handle off of the hose? DON'T try a coat hanger again it ...

...try again. Otherwise, if that's not it, most like the fan portion inside to create air movement has separated from shaft of motor assembly. You may try top open top and reconnect, but if you not sure ...

...separate part. my CV750 comes on but makes a very loud noise. it sounds like something is stuck then it lets loose but the noise sounds terrible and the unit smells warm. I installed a new bag and ...

no suction when using wand on electrolux precision upright When I go to use the wand separately I have no suction. vacuum works fine otherwise/ There is a ball valve between the wand hose and the base

...stuck. This problem should not happen as often as I see other people also having this problem. Must be a poor design on Hoover’s part. It takes about 30 minutes and a Phillips screw ...

...stuck in with an old toothbrush etc to get all the fluff & dirt out, and give the mesh on the left-hand air intake a good scrubbing with the brush too (just like cleaning out the other filters). ...

...separate, you will see under the bag chamber that there are two wires you have to disconnect from the bag switch Remove those two wires from the bag switch Now you can completely remove the bag ...

...separate the wand competely - point the wand into the air or at a source of light (please don't point it at the sun) and look through the metal rod part - the handle is bent but you should still see ...

stuck. This problem should not happen as often as I see other people also having this problem. Must be a poor design on Hoover?s part. It takes about 30 minutes and a Phillips screw driver and wrench.