Jl Audio 1000/1 Car Audio Amplifier "amp run" Questions

...amp should run comfortable at 2 ohms/channel. However, your dual voice coil subs are rated at 4 ohms. This means when you connect the 2 voice coils together in parellel (positive to positive and ...

...amp, you run two 4 ohm dual voice coils to the amp + -, + - If the subwoofers are 2 ohm, run + - on only one voice coil to the box for each and run + -, +- for 2 ohm load on amp or + - bridged for 1 ...

amp settings for a 500/1 to run a jl audio 13w6v2 d-4 ! amp settings for subwoofer wired series ! an amp setting for sub wired parallel ! series would be 8 ohm an parallel would be 2 ohm ! an can this

...run to the amp from the headunit. Make sure when you run it that you run it away from the power wire to prevent from having engine noise. You also need a ground wire, wich should be to a stud on the ...

...amp; i run 2 amps as well, cameto find out i had a neg. & positive touching , so check all ur wiring for tht amp.. u need more capanice general fourmla 100watts 4 .5 farad or run 2 car batt in ...

...amp to run at 2ohms 1300w rms to the sub and the other hifonics amp to run at 2ohms 1300w rms to the sub, and i want them to share a 3 farad capacitor but i want to each amp to individually run each ...

...amp. 4guage run a ground from car frame to amp.(scratch paint off under the carpet in the truck and screw it down. run a remote line from the radio to the amp.( blue wire) if using for sub run rca ...

...amp I run 2 6 inch alpine S's to the front to the front RCA inputs of the head unit, & 2 Pioneer 440w 6x9 inch speakers to the rear inputs. & my 800w 12 inch sub from my 2 channel amp to the ...

...amp is not 2ohm stable and you will destroy it. Some amps actually all ready run a bridged output for left/right operation, this could also be the reason why the protection circuit is kicking on. ...

...run both efficently Go by the fuse rating on the amplifier as a default. i.e. - If on amp has a 40 amp fuse on the outside and another has a 30 amp fuse on the outside, then you need to supply at ...