2003 Toyota Corolla "key switch replacement 2006 jeep" Questions

...switch. Turn the key, lights/radio, etc come on, but Jeep wont' start. Hear a click behind right dashboard. First, make sure you can turn the engine by hand. If you can't then the starter can't turn ...

...switch replaced because the dash lights and headlighs would just flash and turn off while I was driving. Now the check engine light is on and flash It also shakes when I drive, and the key gets stuck ...

key in my jeep to turn to lock and come out of the ignition bad pin may have to replace ignition switch I don't understand your question exactly actually. But I want to suggest you to spray WD-40 into

switch.(power in, power out key turned to start). Tests can be done with a test light but I prefer a volt meter because it not only tells me power is there, but how much. Likely your problem is at the

...key on,and use your test light to probe the wires before they enter the bulb sockets for power,if you have power replace sockets,if not check to make sure wires are still connected to back up light ...

...key in switch in accessory setting. Tried a jump start to no avail. Car started but stopped when accelerator pushed down. Now, no grinding sound as in engine trying to kick over. No sound, but ...

...2006 power lock will lock but not unlock My power locks will work to lock all of the doors but not unlock any of them ... I was playing with the power lock and randomly 3 doors (not the driver) ...

...key to start, it will eventually start. Not a good thing. First thing to try is clean the battery cable connections, and make sure they are tight. Sometimes, if they are a little bit loose, or dirty, ...

...key over it does everything but start. All lights work everything. I have already changed the ignition. It doesn't crank or anything. I can hot wire it and it starts right up. Any ideas what could be ...

...key check relay, there are 2 relays on the outer side of the battery tray. One is the fuel pump relay, and the other is for the Idle control motor if need be you can switch them to see if that's the ...