1994 Toyota Previa "install thermostate" Questions

1993 lucinda diesel overheating check fluid level of coolant, thermostate, and fan. Flush system and install new antifreeze.

...for coolant seepage, which leaves a crusty beige or pink deposit. If so, replace the water pump.] Install a new thermostat and gasket (Or O-ring). Refill the coolant with the same coolant only if

...install the new thermostate tightn the hose replace your filter and fill the over flow resivor only to the point on COLD MAX. take the cap off the radiator start the car wait for the thermostate to ...

...housing is where the lower hose is connected to remove the 3-12mm bolts and remove the thermostate be sure to install it correctly. there is a small spike has to be pointing up.replace the

thermostate correctly instalation the thermostate have a metalic piece for block one way , one block the side on the bock or block way on the hoses the thermostat spring part goes down position in the

...thermostate is located so I can change it.. Just follow the upper radiator hose to the housing that it is connected to. Remove the radiator hose, and then the housing itself. The thermostat is under ...

...vehical 205-210 is right at the normal range Normally you will have the 185-210 deg. thermostate installed in this vehical '' You should notice that it does go up and you notice that it goes back ...

...cold. When sensor is removed, fans work to cool radiator. Otherwise, do not kick on. Thermostate installed correctly and works. Coolant leaks under engine area when hot. We are stumped. Thank you. ...

...replace with new gasket and thermostate tighten bolts install hose fill rad with coolant water mix 50/50 and run engine with heat on floor until gets hot and you see coolant flowing in rad, install ...

...thermostate w/ a160 degree. 1: was that ok? 2:Stupid me-forgot to notice how it was removed so I could re-install same way......does the spring, go toward the engine or in the housing? Thank You very ...