2007 Toyota Corolla "oil control valve solenoid" Questions

...Control Circuit High Areas to check: Short in shift solenoid valve No. 2 circuit Shift solenoid valve No. 2 ECM Check the shift solenoid valve No. 2 when DTC P0976 and P0977 is output. Check harness ...

...control. Just replace that. They do go haywire from time to time. Also check the electrical connection plug first, oil aand contamination can cause the same problem. Cleat both ends of the electrical ...

...oil. Is the heck engine light on? If so, you need to get the code read. If not, check for loose connection around the air intake and mass air flow sensor. Also check for disconnected vacuum hoses. I ...

oil flow to control timing, dirty oil can cause the valve to stuck open or close. Before replacing the valve, change engine oil and filter and reset engine code. Possible Causes: - Intake valve timing

...timing control solenoid valve uses oil flow to control timing, dirty oil can cause the valve to stuck open or close. Before replacing the valve, change engine oil and filter and reset engine

oil control solenoid. If it is out of spec, too high, an intermittent fault will occur until the resistance gets so high or goes open circuit and the engin performs poorly. My experience has been on a

...> p1111_nissan Since the Intake valve timing control solenoid valve uses oil flow to control timing, dirty oil can cause the valve to stuck open or close. Before replacing the

...angle at the control position. Could be a problem with the control valve, oil flow to the valve, or one of the cam or crank sensors.Read more: ...

...oil flow to control timing, dirty oil can cause the valve to stuck open or close. Before replacing the valve, change engine oil and filter and reset engine code. When is the code detected? When there ...

...engine oil - Low engine oil level - Faulty intake valve control solenoid - Intake valve control solenoid harness is open or shorted - Intake valve control solenoid circuit poor electrical ...