1991 Peugeot 405 "put power steering pump 1996" Questions

Ad

put in tank and killed the diesel pump diesel pump replaced but is running under power and smoking any ideas ??? Better would have been to get the diesel injectors checked too.( Cleaned and calibrated

Ad

...put a power steering pump on and the same day my water pump went out they told me that win a altinator are power steering pump messes up it woorks the watter pump more and can cause them to mess ...

Ad

...in the same. They are both hydraulic fluid. Only the red dye. Your vehicle will operate fine on transmission fluid in the power steering pump. Just don;t put power steering fluid in your ...

...power steering pump was leaking so replaced the front seal and sealed the pump up and put it back on, now i carnt blead it up after running for less than a minute the fluid airates, any help? turn ...

Question about Peugeot 405

1 Answer

...power steering pumps? you probably have debris trapped in the lines and it creates more everytime you put a new pump on it. Some oil change shops offer a p/s system flush. try this before you replace ...

Where do I put in Power Steering Fluid in a 1996 Buick Regal? In reservoir on power steering pump on drivebelt side of engine, (passenger side).

Question about Peugeot 405

1 Answer

...power steering, its extreamly hard to turn the wheel when coming out of a compleat stop, i have put in some fluid but does not help much first of all when was it you did the last tune up? and the ...

Question about Peugeot 405

1 Answer

...put the power steering fluid? It should be a bottle amongst the engine block somewhere, usually it's near to the windscreen washer pump and brake fluid pumps. At the front of my engine I have a huge ...

Question about Peugeot 405

1 Answer

steering is hard when turning to the left no noise Try putting some power steering additive in the pump to loosen up sticky valves in the power steering rack. Good luck. Neil W.

...power steering pulley remover an one to put it back is a different tool installer there should be 3 bolts holding the pump on,as far as the belt the diagram should be under the hood run the belt ...

Not finding what you are looking for?
1991 Peugeot 405 Logo

638 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1990 Peugeot 405
1990 Peugeot 405

103 Questions

2005 Peugeot 405
2005 Peugeot 405

805 Questions

1989 Peugeot 405
1989 Peugeot 405

164 Questions

2006 Peugeot 405
2006 Peugeot 405

161 Questions

Top Peugeot Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...