1990 Peugeot 405 "crank sensor plug" Questions

Ad

...Crank sensor or engine speed sensor is faulty. Fault: Irregular power loss on accelerating The speed of the engine is limited till 2500rpm Frequent loss of crankshaft position sensor signal Cause: It ...

Ad

Question about Peugeot 405

1 Answer

...405 gl 98 dual fuel petrol and lpg firer but wont start plenty of fuel in and petrol is getting to the carb check the crank sensor or the cam sensor behind the pully,s to make sure there plugged

Ad

Question about Peugeot 405

1 Answer

...ground on the crank angle position sensor (some manuals call this the speed sensor). The original black insulation was gone and the ground wire was frayed. Replace this part and your car will fire

...been through this nightmare.Checked out immobaliser not the answer.Changed Coil £70 not the answer.Changed crank sensor 20 min job £55. BINGO.Started first time. Hope this helps Greasy ...

Question about Peugeot 405

2 Answers

...to know what the problem is can u help me. water in the ignition coil. have you had your car plugged into a computer to find the code ? could be a crank sensor fault,does it restart straight

Question about Peugeot 405

1 Answer

...crank sensor,cam sensor,pcm,wired cam and crank sensor direct to pcm,replaced coil, plugs and wiresand air intake temp sensor...also replaced plug ends to crank and cam sensors sounds ike it could be ...

...crank sensor,engine crank good but no spark to spark plugs,or signal from crank sensor,checked wire from crank sensor plug to PCM wires 100% Has the wiring harness to the sensor been checked all the ...

Question about Peugeot 405

1 Answer

spark from a pulled plug - - If the crank sensor is bad you will not get any spark. The PCM does not know the engine is turning with no crank sensor signal so it it does nothing. What else is it doing

Question about Peugeot 405

1 Answer

...crank sensor 2003 suzuki aerio 2wd will crank, but not start. I mistakenly pulled the battery removing the engine codes. Fuel pump comes on, but can not get fire to plugs. Friend said it might be the ...

changed crank position sensor, new plugs,wires and coil,car will turn over but will not crank, however its a manuel transmission plugs.wires.coil,crank position sensor, head gaskets Check plugs wires

Not finding what you are looking for?
1990 Peugeot 405 Logo

149 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1991 Peugeot 405
1991 Peugeot 405

451 Questions

2005 Peugeot 405
2005 Peugeot 405

805 Questions

1989 Peugeot 405
1989 Peugeot 405

164 Questions

2006 Peugeot 405
2006 Peugeot 405

161 Questions

Top Peugeot Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...