...a steel bar which goes between both front wheel hub assemblies. At each end is a ball joint. The off side (o/s) end is the right hand (looking forward) or Drivers Side in the UK. Hope this helps. ...
...end to stop the front from shacking when i go over 68 mph No, you cannot. If the tie rod end is worn, it has to be replaced. Don't worry, it is an easy job. It might also be the wheel balance or ...
How do i install a steering damper in a 1997 landrover discovery under the front middle of the car is a sideways looking damper undo end nuts and replace
...YOU SET THE FREEPLAY ON A DISCO 2 STEERINGBOX YES. But you only want to do it 1/8 of a turn at a time. once you go to tight there is no turning back. But I would check front end parts first for
...front wheel is off the ground. Grab the wheel and try to turn it back and forth. You should not feel any play. When you find a wheel with play, reach around the wheel with one hand and grab the inner ...
...front end, and then mounting the new light clusters & eyebrows. Not 100% sure if I'd be happy doing it to mine TBH, it does seem a bit "bodgy". May just buy the front end off a crunched one (that ...
Question about Land Rover Discovery
front end whine under load acceleration Hi, Have a whine in the front end when accelerating on an incline. Can feel it in the steering, although not a shudder. It is a Land Rover Discovery 3 TDV6 auto
Question about Land Rover Discovery
...front end underneath. I don't know what it could be, and it gradually gets worse. Any idea where I should look next? The ball joints probably have gone,what you have to do ,lift the front of the ...
Question about Land Rover Discovery
I have a chatter noise in the front end when going down the road possibly ball joint or track control arm maybe a loos wheel
where is crank shaft sensor on 2002 LR at lower left rear of engine. looking at the engine from the front ( belt end )
252 questions posted
Usually answered in minutes!
318 Questions
325 Questions
233 Questions
215 Questions
235 Questions