2003 Renault 181 "glow plug relay problems" Questions

relay to glow plugs changed please help i have chucked 1000's at this van and now its getting me down as i need it for work sounds like a bad sensor. the glow plugs should stay on long enough to reach

...espace ,but it still struggles to start ,it will start after about five atempts.it is a 2.2 diesel turbo have the glow plug relay checked or take it to a garage and get a code read done on the ...

...GLOW PLUG PROBLEMS.CHECK GLOW PLUGS RELAY FUSE. .REPLACE AIR FILTER AND FUEL FILTER.IF YOU STILL HAVE PROBLEMS.YOU HAVE PROBLEM IN FUEL DELIVERY SYSTEM .LOOK FOR FUEL LEAKS AT INJECTION PUMP.YOU CAN ...

...glow plug relay problem was still there got **** of with it spending money, i found the problem myself were your ( EGR VALVE IS THERE IS A SMALL NIPPLE AT THE BACK OF IT THERE IS A TUBE ON IT THAT ...

...glow plug problem has been going on since i bought the truck. I replaced the glow plug relay last week however the truck is still having problems starting. when i turn the key on the relay kicks on i ...

...glow plug issue. perhaps a bad glow plug relay. I would think its the relay if the problem comes and goes. If it were a bad glow plug the problem would be constant. check for volts at the glow plugs ...

...glow-plug relay and the blinking of every other light that is on in sync with the clicking sound. If the clicking and light dimming is not observed your power relay to the glow-plug relay is probably ...

...glow plug comes on please help does the glow plug/coil light flash at all???? once would indicate glow plug relay fault! three times would indicate FUEL pump failure! sorry never experienced two ...

...glow plug light and my car smells of burning It's most likely a stuck glow plug relay. Use caution and check which glow plug is hot/warm when the car is OFF. When a glow plug relay got stick, It will ...

...glow plug light on tha dashboard stays on for as much as 10 minutes sometimes. The local garage has tried to fix this with no success. Any ideas? Can I wire in a push switch to control this manually ...