Question about Cars & Trucks
...clutch plate correctly? If you put it in backwards, the pressure plate will not be able to move far enough to release it. If the clutch plate is in correctly, you need to check if the clutch release ...
Question about Cars & Trucks
...plate .the noise stops until you let out the clutch again,the bearing can be replaced without replacing the whole kit,clutch ,pressure plate,thro-out-bearing if money is a issue,...Merry
...clutch plate, slave cylinder, master cylinder, clutch fluid, did all the bleeding, changed gear box oil. Gears still stiff. Hard to get first and reverse gears and stiff for other gears. Are you sure ...
Question about Dodge Cars & Trucks
...clutch disk plate with 10 spline Checking at RockAuto, it looks like the 2.5L Dakotas only used 10-spline clutches in 93 to early 95 models. All clutch discs shown are 9 1/4", but the clutch ...
Question about Saturn Cars & Trucks
...bearing noise but when the clutch is not engaged it goes away The clutch release bearing is going bad due to incorrect clutch adjustment. Damage to clutch pressure plate will occur if not ...
...plate and clutch disc. Do not disassemble the pressure plate assembly; replace it if defective. Inspect the flywheel, clutch disc, pressure plate, throwout bearing and the clutch fork and pivot shaft ...
Question about Cars & Trucks
putting throw out bearing in and holding clutch lever all the way back so it can fall in and don't forget to put clutch brake on shaft, if using 1 piece unit, aftermarket ones break down to easy (****
...plate, clutch disc and throw out bearing. I put the trans back in aaand it continued to slip in the exact same way : / . Took trans out a second time, replaced resurfaced flywheel with brand new ...
Question about Nissan Cars & Trucks
...plate on a 2000 model nissan diesel medium duty truck put new clutch in and the clutch won't engage and it was just slipping at first before the new one Is it possible you put the new clutch disk in ...
...or model, so I can't be exact, but on most cars there is no adjustment. A slipping clutch is worn and needs replacing. Put in a new throwout bearing and pressure plate as well as the driven
728 questions posted
Usually answered in minutes!
554 Questions
410 Questions
304 Questions
0 Questions