2002 Hyundai XG350 "remove front hub 350" Questions

Ad

Question about Hyundai XG350

1 Answer

...remove the front hub on a XG 350 2002 hyundia, to replace the stud, Knuckle needs to be removed and the center hub 'pressed out' using a hydraulic press (accepted procedure). You can avoid this by ...

Ad

Question about Hyundai XG350

1 Answer

...Remove the hub body assembly from the front disc brake hub and rotor. If the body is difficult to remove, install two capscrews and pull the body assembly out of the front disc brake hub and rotor. ...

Ad

...remove hub assembly on front left wheel. I am doing the ball joints and axle shaft joint. Once you remove the locking hub, the hub and bearing unbolt. There are two different styles of locking hubs. ...

Question about Hyundai XG350

1 Answer

...front wheel hubs? Once the truck lifted and on a jack stand, remove wheel, brake caliper and rotor. You should be able to slide the hub off and slide the new one back on. Just put the rotor and ...

...front differential cover, or can it be done by working from the outside. By removing the brake caliper and hub assembly, will that allow me access to replace the seal ??? Most oil seals are just ...

...remove the front hub to get enough room to get the old axle out and the new one in. Remove the axle nut, washer and then tap the axle loose from the hub. Once that is done, work on removing the hub. ...

Question about Hyundai XG350

1 Answer

front wheel speed sensor (WSS) connectors at the frame and harness. Place a Digital Volt Meter (DVM) across the terminals of each WSS connector. Rotate the wheel clockwise approximately one revolution

front wheel speed sensor (WSS) connectors at the frame and harness. Place a Digital Volt Meter (DVM) across the terminals of each WSS connector. Rotate the wheel clockwise approximately one revolution

Question about Hyundai XG350

1 Answer

Remove front disc brake rotor shield (2K004). Refer to Section 06-03 . Disconnect the steering linkage from the integral front wheel spindle and spindle arm by removing the cotter pin and nut and then

...remove the front wheel and the brake. Kind of round casting that holds the bearing and connects the a-frame and upper ball joint together with the tie rod end so the wheel can turn. The wheel studs ...

Not finding what you are looking for?
2002 Hyundai XG350 Logo

390 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...