1995 Saturn Sc "ignition lock cylinder" Questions

...ignition lock. there is always a trick to doing this. what is the procedure? i have a 2001 saturn sc2. There are several procedures in the manual--I think for different models. I think I picked the ...

...ignition lock? Im thinking your going to be ok as far as warranty repair,if your dealers service dept is insensitive, call Saturn assist @ 1.800.553.6000 On to the ignition switch ....separate colum ...

...ignition since it's been damaged the key won't work. There is a nice video on this over on youtube. Shows the guy pulling off the plastic covers and removing the lock cylinder. You can buy a new one ...

the ignition lock cylinder replaced? any ideas...? sounds like its not slotted down into place or bedded bring it back to the person that fitted it and tell them its not fixed properly,.adrian,,,,,,,,

...ignition on my 1995 saturn? There is a very nice video showing a saturn lock cylinder replacement over on youtube, watch that and you will see how to do it. just go to www.youtube and search saturn ...

...ignition Replacing switch & LOCK CYLINDER I have the same problem. I've done the repair on other cars for lest than $20 in 5 minutes. Saturn, unfortunately is not as easy. First off, like all other ...

...ignition's lock cylinder, and then to the car's TDM (Theft Deterrent Module). These 3 parts are in CONSTANT communication. If the key is in the ignition, then these parts are sending signals to each ...

...ignition switch lock cylinders (11582), lock cylinder keys are available for these vehicles or the lock cylinder key numbers are known and the proper key can be made. Disconnect battery ground cable ...

...ignition switch lock cylinder (11582) to the RUN position. Disconnect the ignition switch electrical connector. Remove the two screws retaining ignition switch (11572). Disengage the ignition switch ...

...ignition switch into the lock cylinder housing. The tabs on the ignition switch MUST be seated inside the lock cylinder housing for proper installation. Use a screwdriver to rotate the lock cylinder ...