Hyundai Motor 2002 Elantra "brake fluid used" Questions

...brake fluid? dot 4 brake fluid is suitable to top up all dot specified brake fluids the dot fluids are glycol based fluids are are used widely in the transport industry the are controlled standards ...

...brake fluid to flow more easily back. After you have done that, check the brake fluid level and top off if needed after you have gone for a test drive. Thank you for using Fixya and be safe. Loosen ...

brake fluid before you do. I generally fold a paper towel to one fourth original size and set that on top of the fill hose to keep from squirting fluid into the engine compartment. Use a brake pad and

...fluid" is brake fluid and doesn't usually need to be changed. You add more through what is called the "slave" cylinder. It is usually connected directly to the master cylinder and looks alot like it ...

brake fluid first. What year model make is vehicle? If an older vehicle with rear drum brakes go to an empty parking lot and place in reverse accelerate to about 30 mph and slam on brakes 3 times then

...brake fluid reservoir 2.Loosen the wheel nuts then raise the vehicle and remove wheel 3.Push the piston back into the bore to provide room for the new brake pads.A C-clamp can be used to accomplish ...

brake fluid from a sealed container. Brake fluid will easily absorb water and then you have more problems. The seal should be included in a master seal rebuild kit, and may not be available by itself,

...and old/bad fluid. It should use brake fluid. If it has a cable then you need to adjust the cable to manufactures specs. If that doesn't work then I would look at the installation. I hope this ...

that can come out and be cleaned. Alot of cars do not have an actual "filter" for the trans fluid, just a screen that you can use a "brake cleaner" to clean off and put back when you replace the fluid

...me on this one but i think the slave might be inside the bell housing there slave cylinder is not leaking ,i did use brake fluid ,unless if i have to replace the cylinder ,and how do you remove ...