marks should go. ON THE CAMS THERE IS A MARK ABOVE AN I FOR INTAKE AND AN E FOR EXHAUST LINE UP THE I UPWARD TOWARD THE MARK ON THE BACK OF VALVE COVER AND LINE THE E ON THE EXHAUST SIDE MARK WITH THE
line up marks on all the gears, cams and crank, make sure after you line them up and install the belt you use a wrench and turn the crank bolt by hand two revaloutions and make sure the marks line up,
...some of the valves but hter are marks on the cam gears that line up with marks behind gears you can see them through holes in the gears then the cran has a notch that lines up with mark on the ...
...turn to crank timing mark , insert screw driver in hole if goes in deep and doesnt hit piston, turn to mark again this is top dead center if marks dont line up with piston movement timing has
radiator installation on 2003 Kia Sorento That is a VERY easy radiator.Loosen radiator drain plug and drain coolant from radiator.Disconnect cooling fan connectorsRemove upper and lower radiator hoses
Question about Kia Sorento
...the crankshaft position sensor, and timing belt. Now it won't start. The timing marks all are lined up. The engine will spin over but it will not fire. Check the accuracy of the work and ensure ...
fuel pump replacement on a 2003 kia sorrento how do I replace the fuel pump on a 2003 kia sorrento? Remove negative battery terminal, release tank pressure by opening gas cap, remove the rear seat, ...
Changed timing belt on 2003 Kia Sorento 3.5 ,Timing marks are lined up.Engine starts up and runs smoothly BUT has no power..? If the timing was off by one tooth,Would the car start and run smoothly ...
...i put new plugs wires and coils and didnt change a thing,i removed the two timing belt covers and lined up the marks on the cam on the front and the intake on the back was 2 teeth
949 questions posted
Usually answered in minutes!
787 Questions
780 Questions
590 Questions
148 Questions
163 Questions