1992 Geo Tracker "replacing 95 1" Questions

...95 16v ? what DTC, post DTC? why skip that,... there are many 02 DTC. most fail for heater, dead, lets play a game. say; 1: CEL out running, is it , now? 2: you did the 60k by the book, did you? if ...

...95 geo trackker 1.Remove steering wheel cover from screws in bottom 2. pop off horn cover should snap off 3. Unplug three plugs to switch assembly 4. Remove steering wheel nut pull steering wheel may ...

95 Geo Tracker Dash Lights out? My stereo is run off an amp under the console and it's been acting up, I think theres a grounding wire because it keeps blowing the fuse everytime i replace it.. The ...

95 , 16valve ? engines, says so on top of engine valve cover. all that is last. key on, CEL glows? if not fix that first key on, does CEL go out, running, ? if not pull the ECU DTC codes using a paper

...95-AC-elect-draw.jpg now your answers. $4 answer https://suzukipitstopplus.com/Products/1198-1994-1995-sidekick-service-manual.aspx free, chapter 1b http://www.acksfaq.com/96-FSM-v1-1b-pdf.htm i have ...

95 came with 2 engines, 8valves and 16valves, they work differently (8v love so race, 16v loves to stall) 1: ISC Stuck open, common. 2: 8v, any air leaks at all , will cause super high idle speeds. 3:

...95 all had/have bad huge internal capacitors. http://www.fixkick.com/ECU/ECU.html that love to leak, short and or explode. if they have back skins and say Rubicon on side, bingo , TRASH CAPs. in the ...

...95 cars mechanically are somewhat of a blend of the XJ40 and the XJ300. Remove these screws, and note any spacers that were behind them. These spacers get lost quickly, and cause the ski slope to sit ...

...--------- Step 1: Torque from 47-53 Nm (35 to 39 Ft/Lbs) Step 2: Back off all bolts 360 Step 3: Torque from 27 -33NM (20 to 24 Ft/Lbs) Step 4: Torque rotate 85-95 Step 5: Torque rotate additional ...

...for fuel. obd 1 scanned a code 95. replaced in tankfuel pump. still starving for fuel? code 95 refers to secondary pump that is located on the frame rail. Could be bad pump could be wiring to