1998 Jeep Grand Cherokee "blower replacement" Questions

blower motor does not work Blower motor for heater and a/c does not work. I removed it and checked with battery outside vehicle-OK. Replaced blower motor relay in fuse box passenger side-OK. Replaced ...

...replacement is necessary this could be either a bad blower motor or this could be a bad blower motor resistor. check all fuses first if all are good disconect the wiring harness from the blower motor ...

my blower fan is not working Hi, have you check the fuses, if they or good check and see if you have power at blower motor resistor and none at blower motor replace resistor ,if there is power at ...

ac blower won't work. Resistor has been replaced 3 times. I think it is the problem now. Is it easy to replace? Where is it? where is the blower motor resistor for the ac. Is it hard to replace? 2000 ...

...coolant overflow bottle retaining strap remove the coolant overflow bottle and bracket. Unplug the blower motor. Remove the 3 blower motor bolts.Remove the blower motor. Remove the blower motor fan ...

98 Grand Cherokee blower fan works sparatically on all settings except low chrysler blower motors pull alot of amps replace motor and resistor card Check the fuse first,pull it out and look in where ...

FAN BLOWER (FOR A/C AND HEAT) ONLY BLOWS ON THE HIGHEST SETTING. IS THERE A FAN SPEED CONTROL OR RELAY THAT CAN BE REPLACED, OR IS IT SOMETHING ELSE? Hello leebarker The blower moter switch or the ...

2006 jeep grand cherokee heat & air will not come on at all. I just replaced the blower resistor but that did not correct the problem. Any ideas? Hi, My first thought of the culprit would be a ...

I have a 2000 Jeep Grand Cherokee Limited that The blower motor resistor was melted so I replaced it two months ago no I have a new melted resistor just like the old one and my blower dont blow again ...

rad/hvac fuse keep blowing every time i put a fuse in it blows Your Blower motor is going bad drawing to much amperage if you keep replaceing the fuse you can melt the connector where it plugs into ...