...on, get an emissions code, they told me to change gas cap, did, light stayed out 2 day, came back on, what else could it be, thanks crank shaft sensor or cam sensor crank shaft sensor or cam ...
...sensor is and also where the pickup coil is located. Thank you very much. cam sensor is in distributor .crank sensor is on drivers side top of trasmission bell housing if it is a 1996 grand ...
...cam sensor which just shows when #1 cilyder is up. Yes it could be the distributer.If its in that condition the chances are that its cracked.Get it changed. my 1996 jeep cherokee grand will turn over ...
...sensor and still same problem ...only now I dont get any codes...anyone know what to do to fix this problem short of sending it to the scrap yard.... back firing ( explosions in the exhaust) can be ...
cam sensor. You could also have a bad fuel pump or pump relay. Crank sensor is on the bellhousing at about 11 o'clock looking from the rear. It is even with the position of the flywheel. cam sensor is
Question about Jeep Grand Cherokee
circuit. changed cam shaft positioning sensor twice.still cranks did start once ran for 5 min. changed the sensor again. no luck. help please. keith Amazing!.. .did you take it in to have it diagnosed
Question about Jeep Grand Cherokee
check engine light still on after changing crank and cam sensors After changing my crank position and cam position sensors my jeep runs fine but the codes still show up and check engine light is still
Question about Jeep Grand Cherokee
...above idle , to where will not run only idle not well, runs well cold changed, coil, plugs cap router and distributor no change check cam shaft possition sensor and crack shaft possition ...
...well as for support. you can look up more specific info for your vehicle on e-how.com. just type in for example : signs of a bad cam sensor on what year vehicle, how to change the part on vehicle
3,696 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions