1997 Volvo 960 "cutting hole floor car" Questions

...it,I would not suggest cutting hole in floor,you might cut wires or even worse fuel lines ( ca-boom ) the tank is not to hard to drop.( should just be 2 straps holding tank up. good luck. ...

...hole location? You would have to figure out a way to cut the floor without cutting the tank. The gap is less than one inch. And the fuel lines come out with the sending unit. They have to be ...

...hole in the floor for fuel pump access ? Don't cut anything. Drop the tank. dont cut the trunk un bolt the straps and drop tank safer ,easier,and less chance of damaging tank/hoses and electrical ...

...can do it without damaging anything. it is all up to you. I would make sure to seal it back tight after cutting the hole. Don't use anything bit a chisel. I have never seen it done but it's your

how to replace fuel pump through the floor 1990 ford tauras You would have to cut a hole in the floor under the back seat like any other american made car. 

hole f0r fuelpump replacement Not a good idea to do this. If you cut threw a fuel line while cutting the floor, You will catch the vehicle on fire. This would be very difficult to put out, because the

...floor and defrost vents that gets the air. It's a ~$40 dual action bellow sort of up over the gas pedal that is malfunctioning. You can put a band-aid on it by removing the kick panel over the pedals ...

I have a 1995 dodge neon need to make an access panel for fuel pump where do I need to cut , have no ability to drop the tank go to the junkyard and look at a fuel tank for a neon and you'll know. or ...

...hole" would be quite the endeavor and done correctly would add quite the additional time and expense. Decline cutting holes and drop the tank in order to service the pump/sender. Any reputable repair ...

...is in the middle of tank. I don't know if you would want to cut hole in floor of surburban to reach pump? I don't have any info about cutting that hole, if you try that, that is your