1991 Volvo 940 "ignition switch" Questions

IGNITION IS SWITCHED ON. I HAVE HAVE TO REMOVE THE FUSE BUT THIS CIRCUIT ALSO CONTROLS THE HORN SO NEED TO GET THIS FIXED A.S.A.P. WITHOUT TOO MUCH EXPENSE WOULD REALLY APPRECIATE YOU HELP IF YOU KNOW

no ignition lights car will not start check your battery connections should be clean and tight. if ok change the electrical part of your ignition switch.

...Switch on ignition and check that fuse has not blown- if it blows under these conditions the short or overload to ground is:- a) in the wiring to one of the units, b) or there is some other ...

...ignition switch. If it happened most at high speed, but would restart at idle after stoping, then I would suspect fuel filter or pump. You could also check the gas tank vent valve, by opening he cap ...

...how this works? not sure what you want main feed thick cable goes from battery pos to starter solenoid thin wire goes from ignition switch to small terminel on starter solenoid that is a basic ...

...battery, anti theft wont disengage U MUST LOCK ALL DOORS and unlock with key place key in ignition switch turn on but do not start wait three minutes or until security light goes off then ...

Engine tursn off at stop lights 1993 Volvo Turbo 940 had the ignition module replaced but the engine turns off at stop lights. Resolution would be welcome. thank you for your expertise with this ...

...ignition switch to the ON position(engine not running). Enter the diagnostic mode by pressing the push button on the diagnostic unit for at least 1 second, but not more than 3 seconds. The red LED ...

I belive you may have a failing/loose ignition switch. Not uncommon especially if you have multiple keys or key rings attatched. Every time you hit a bump it jerks the key and beats the switch inside

ignition switch fuel pressure ok will be ok for a while then fault returns I would replace the fuel pump relay, and the engine speed sensor. I would need more information to rule one or the other out,