1991 Jeep Wrangler "change clutch slave cylinder" Questions

Ad

Question about Jeep Wrangler

2 Answers

...clutch slave cylinder leaks what does it consist of to change it Remove the bolts holding the slave cylinder to the transmission. Disconnect the hydraulic hose. Reconnect hydraulic hose to new slave ...

Ad

Question about Jeep Wrangler

2 Answers

clutch master under the dash and also the slave cylinder and replact the leaking part It's probably your slave cylinder. On my '89 it was located in the clutch housing. You have to take the tranny off

Ad

...change the slave cylinder YES U DO THE SLAVE CYLINDER IS ATTACHED TO THE CLUTCH RELEASE BEARING. no but you may want to bleed it before you reinstall it the 1990 4.2L has an internal slave cylinder ...

...slave cylinder or both? yo it could just be out of fluid! it could actually the master cylinder because all the gear changing with the clutch goes through the master cylinder but i would go to the ...

//www.jeepforum.com/forum/f9/how-change-bleed-clutch-slave-cylinder-511531/ your jeep has no center differential or read prop shaft slip clutch like one year had. so it not full time 4wd its part time

Question about Jeep Wrangler

4 Answers

...clutch's master or slave cylinder have worn out but you may want to suction the old brake fluid out and replace with new and try. This master cylinder will be near the one for the brakes but smaller ...

Question about Jeep Wrangler

1 Answer

...to turn it over. Is there a easy fix for this? Changed clutch, throwout, pilot bearing and rear seal. did you get your slave cylinder blead? does the tranny disengage when you push in the

...change the master cyl, as it is likely internally bypassing and permitting the clutch to release. PS it takesa a special "touch" to shift gears without using the clutch, if you cannot do that don't ...

Question about Jeep Wrangler

1 Answer

Why won't my gear shift change gears? If the clutch is not releasing,then this would cause the problem,check the slave cylinder,and see if it is pressing the clutch.

...change-bleed-clutch-slave-cylinder-511531/- cheers Denny worst case may be the springs broken from the clutch and pinned behind the pressure plate. this would make it not release the clutch. it could ...

Not finding what you are looking for?
1991 Jeep Wrangler Logo

481 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...