...little notches cut into the big pulley one lone mark and three in a group line up that middle notch in the trio with a timing mark just behind the pulley on the block or plastic timing cover ...
...line up the balancer. I noticed that the balancer pully has a dot for marking and everytime I insert the 6x100 mm screw it sets in three different positions. My question is what is the right position ...
Question about Honda Accord
...Three ways to check: remove the timing belt cover and inspect for damage; line up the timing mark on the crankshaft to Top Dead Center (TDC) and check the camshaft timing mark; or check each cylinder ...
...three retaining bolts on the distributor and rotate the distributor until you get the line up. Tighten the bolts and recheck the timing. NOW, how to start the car so you can do that? Not the first ...
line at the right end of the fuel rail). Remove the mounting nuts (four) and detach the fuel rail and injectors from the intake manifold. Remove the injectors from the fuel rail and remove and discard
Question about Honda Accord
...three (34 mm) Lock Nuts (including the left handed one for the Main Shaft?) Same question for the Conical Spring Washers. -What is the best source for the "lock washer/plate" used on the Park Lever ...
Question about Cars & Trucks
...line up. There are three timing chains on these engines. On my Sorento even after the timing marks have been set and the engine is rotated by hand, after numerous revolutions the timing marks do not ...
Question about Honda Accord
...and both camshafts, MUST be lined up for the valve timing to be correct. Once set properly, they will not change. Every two revolutions of the crankshaft, all three marks should again line up
...timing on a 1991 Volvo 740. There are marks for all three. Cam and Aux shafts have dots on face of outer gear. Cam lines up with mark on rear timing cover(about 1 o'clock). Aux lines up with mark on ...
Question about Honda Accord
...three marks on it .the double line is for your crankshaft line it up with the timing mark. a singe line should then line up with the timing mark for your camshaft. the next line will line up with the ...
1,149 questions posted
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions