2003 Honda Odyssey "front brake" Questions

front brake rotors checked. When rotors go "out of round" they will grab a little when applying the brake. If you also feel a vibration in the brake pedal then this is definitely the problem. Have the

...front brake but the back brake needs to be replace. The reason cos the van is not being driven too much aswell from the snow and ice and salt accumulation over Winter. We have the van for over 6 yrs ...

...front brake pads on 2006 Honda civic gas model jack up front, remover tire, remove bolts on backside of caliper, slide caliper off bracket, remove old pads (paying attention to how they fit in), ...

...brake on for front pads.. Remove wheels and spread old pads back to push cylinders back in their bores on calibers to allow for thickness of new pads. Remove the 2 sliding claiber retaining bolts and ...

...front brake rotors for 2004 odyssy? install front brake rotors for 2004 odyssy? 1. remove 2 bolts holding caliper on (either 12 or 14 mm) 2 remove 2 bolts holding caliper bracket (which holds the ...

...front brake pads on one side are not fully releasing their grip on the brake rotor when you remove your foot from the brake pedal, the car will tend to drift off centre when driving and especially ...

...brake pads in front and back recently due to noisy vibration when braking and not braking. Dealership ground the rotors but said that they were still badly corroded (as if we had the car in a beach ...

brake and power steering fluids with new one.will you give me some steps in do it yourself?thanks. As you are bleeding the brakes, start w/the furthest line (right rear), have someone add fluid at the

I hear a high pitched whine but it seems to be driving ok Sounds like your front brake rotors are warped. You will either need to have them turned back straight on a brake lathe or have them replaced

...front rotors are warped this is a very common problem on Honda cars . Honda recommends machining the rotors on the car to prevent this. using a machine called an "on car brake lathe" if your rotors ...