2000 Cadillac DeVille "cylinder misfire" Questions

...cylinder 6 misfire on my 00 cadillac deville. do u think the plugs need to ne replaced? Usually, if you only have 1 cylinder misfiring, you have either a bad spark plug or bad spark plug wire. If you ...

...cylinder misfire and car is running rough. Check engine light comes on and after a while it starts to flash. I changed the plugs and cleaned the boots. There are no wires, the problem is still there. ...

cylinder 6 misfire for 2000 cadillac deville 4.6 liter engine wanted a diagram of which is cylinder 6 on the coil pack of a 2000 cadillac deville check out this tool. Brand new on the market and it ...

...the same cylinder, number 8, what do i do next? DO SPARK PLUGS AND WIRES CHANGE IF NOT HAVE DONE TUNE UP IN A LONG WHILE. CLEAN FUEL INJECTORS.CLOGGED FUEL INJECTORS WILL CAUSE CYLINDER MISFIRE

...CYLINDER MISFIRE, COULD HAVE BAD SPARK PLUGS OR WIRES.BAD IGNITION COILS,COULD HAVE DIRTY FUEL INJECTORS,SLIGHTLY CLOGGED FUEL FILTER MANY THINGS WILL CAUSE MISFIRE BUT CODE SCAN VECHICLE SEE WHAT ...

...misfire p0300 started. The car will idle high then low and shakes. Plugs wires intake manifold gasket injectors fuel filter egr idle control sensor temp sensor 4 02s all been replaced I don't think ...

...Cylinder 6 misfire detected. I have already replaced the Injector and still have the same faults how do i check the electrical signal to the injector With a noid light . 9pc Electronic Fuel Injection ...

...misfire at cylinder #2. In this case, the ECM is merely indicating a misfire in general. If you are experiencing the engine running rough, replacing ignition parts starting with spark plugs and wires ...

...cylinder misfire 4 Car jerks when first cranked up and it jerks sometimes when coming to a stop. I got the codes read and it was mostly O2 sensors (which I replaced), misfiring on #4 (new spark plugs ...

...HAS A MISFIRE ON THE ONE AND THREE CYLINDERS IT RUNS REALLY BAD RIGHT NOW DOES IT NEED A NEW ENGINE OR SHOULD I GET A NEW CAR? check the cylinder for compression,, make sure the firing order is ...